Two-Phase Heating in Flaring Loops

Chunming Zhu, Jiong Qiu, Dana W. Longcope

We analyze and model a C5.7 two-ribbon solar flare observed by SDO, Hinode and GOES on 2011 December 26. The flare is made of many loops formed and heated successively over one and half hours, and their footpoints are brightened in the UV 1600 A before enhanced soft X-ray and EUV missions are observed in flare loops. Assuming that anchored at each brightened UV pixel is a half flaring loop, we identify more than 6,700 half flaring loops, and infer the heating rate of each loop from the UV light curve at the foot-point. In each half loop, the heating rate consists of two phases, an intense impulsive heating followed by a low-rate heating persistent for more than 20 minutes. Using these heating rates, we simulate the evolution of their coronal temperatures and densities with the model of "enthalpy-based thermal evolution of loops" (EBTEL). In the model, suppression of thermal conduction is also considered. This model successfully reproduces total soft X-ray and EUV light curves observed in fifteen pass-bands by four instruments GOES, AIA, XRT, and EVE. In this flare, a total energy of 4.9×10^30 ergs is required to heat the corona, around 40% of this energy is in the slow heating phase. About two fifth of the total energy used to heat the corona is radiated by the coronal plasmas, and the other three fifth transported to the lower atmosphere by thermal conduction.

Original Article:

Does Nearby Open Flux Affect the Eruptivity of Solar Active Regions?

Marc L. DeRosa, Graham Barnes

The most energetic solar flares are typically associated with the ejection of a cloud of coronal material into the heliosphere in the form of a coronal mass ejection (CME). However, there exist large flares which are not accompanied by a CME. The existence of these non-eruptive flares raises the question of whether such flares suffer from a lack of access to nearby open fields in the vicinity above the flare (reconnection) site. In this study, we use a sample of 56 flares from Sunspot Cycles 23 and 24 to test whether active regions that produce eruptive X-class flares are preferentially located near coronal magnetic field domains that are open to the heliosphere, as inferred from a potential field source surface model. The study shows that X-class flares having access to open fields are eruptive at a higher rate than those for which access is lacking. The significance of this result should be moderated due to the small number of non-eruptive X-class flares in the sample, based on the associated Bayes factor.

Original Article:

Scale Selection in the Stratified Convection of the Solar Photosphere

M. Kessar, D.W. Hughes, E. Kersale, K.A. Mizerski, S.M. Tobias

In this paper we examine the role of stratification in setting the scale for turbulent anelastic convection. Motivated by the range of scales observed in convection at the solar photosphere, we perform local numerical simulations of convection for a range of density contrasts in large domains. We analyse both the Eulerian and Lagrangian statistics of the convection and demonstrate that increasing the stratification shifts the scale of the most energetic structures in the flow to smaller scales; furthermore the relative amplitude of vertical to horizontal flows in the convection decreases with increasing stratification.

Original Article:

Plasma evolution within an erupting coronal cavity

David M. Long, Louise K. Harra, Sarah A. Matthews, Harry P. Warren, Kyoung-Sun Lee, George Doschek, Hirohisa Hara, Jack M. Jenkins

Coronal cavities have previously been observed associated with long-lived quiescent filaments and are thought to correspond to the associated magnetic flux rope. Although the standard flare model predicts a coronal cavity corresponding to the erupting flux rope, these have only been observed using broadband imaging data, restricting analysis to the plane-of-sky. We present a unique set of spectroscopic observations of an active region filament seen erupting at the solar limb in the extreme ultraviolet (EUV). The cavity erupted and expanded rapidly, with the change in rise phase contemporaneous with an increase in non-thermal electron energy flux of the associated flare. Hot and cool filamentary material was observed to rise with the erupting flux rope, disappearing suddenly as the cavity appeared. Although strongly blue-shifted plasma continued to be observed flowing from the apex of the erupting flux rope, this outflow soon ceased. These results indicate that the sudden injection of energy from the flare beneath forced the rapid eruption and expansion of the flux rope, driving strong plasma flows which resulted in the eruption of an under-dense filamentary flux rope.

Original Article:

Solar type III radio burst time characteristics at LOFAR frequencies and the implications for electron beam transport

Hamish A. S. Reid, Eduard P. Kontar

Solar type III radio bursts contain a wealth of information about the dynamics of electron beams in the solar corona and the inner heliosphere; currently unobtainable through other means. However, the motion of different regions of an electron beam (front, middle and back) have never been systematically analysed before. We characterise the type III burst frequency-time evolution using the enhanced resolution of LOFAR in the frequency range 30 to 70 MHz and use this to probe electron beam dynamics. Methods. The rise, peak and decay times with a 0.2 MHz spectral resolution were defined for a collection of 31 type III bursts. The frequency evolution is used to ascertain the apparent velocities of the front, middle and back of the type III sources and the trends are interpreted using theoretical and numerical treatments. The type III time profile was better approximated by an asymmetric Gaussian profile, not an exponential as previously used. Rise and decay times increased with decreasing frequency and showed a strong correlation. Durations were smaller than previously observed. Drift rates from the rise times were faster than from the decay times, corresponding to inferred mean electron beam speeds for the front, middle and back of 0.2, 0.17, 0, 15 c, respectively. Faster beam speeds correlate with smaller type III durations. We also find type III frequency bandwidth decreases as frequency decreases. The different speeds naturally explain the elongation of an electron beam in space as it propagates through the heliosphere. The rate of expansion is proportional to the mean speed of the exciter; faster beams expand faster. Beam speeds are attributed to varying ensembles of electron energies at the front, middle and back of the beam.

Original Article: