AWARE: An algorithm for the automated characterization of EUV waves in the solar atmosphere

Jack Ireland, Andrew R. Inglis, Albert Y. Shih, Steven Christe, Stuart J. Mumford, Laura A. Hayes, Barbara J. Thompson, V. Keith Hughitt

Extreme ultraviolet (EUV) waves are large-scale propagating disturbances observed in the solar corona, frequently associated with coronal mass ejections and flares. They appear as faint, extended structures propagating from a source region across the structured solar corona. Since their discovery, over two hundred papers discussing their properties, causes and physical nature have been published. However, despite this their fundamental properties and the physics of their interactions with other solar phenomena are still not understood. To further the understanding of EUV waves, we have constructed the Automated Wave Analysis and REduction (AWARE) algorithm for the measurement of EUV waves. AWARE is implemented in two stages. In the first stage, we use a new type of running difference image, the running difference persistence image, which enables the efficient isolation of propagating, brightening wavefronts as they propagate across the corona. In the second stage, AWARE detects the presence of a wavefront, and measures the distance, velocity and acceleration of that wavefront across the Sun. The fit of propagation models to the wave progress isolated in the first stage is achieved using the Random Sample and Consensus (RANSAC) algorithm. AWARE is tested against simulations of EUV wave propagation, and is applied to measure EUV waves in observational data from the Atmospheric Imaging Assembly (AIA). We also comment on unavoidable systematic errors that bias the estimation of wavefront velocity and acceleration. In addition, the full AWARE software suite comes with a package that creates simulations of waves propagating across the disk from arbitrary starting points.

Original Article:

Thermodynamic Properties of the Evershed Flow in the Lower Chromosphere

Debi Prasad Choudhary, Christian Beck

We used spectropolarimetric observations of a sunspot in active region NOAA 11809 in the Ca ii line at 854.2 nm taken with the SpectroPolarimeter for Optical and Infrared Regions (SPINOR) at the Dunn Solar Telescope to infer thermodynamic parameters along one hundred super-penumbral fibrils that harbor the inverse Evershed flow. The fibrils were identified in line-of-sight (LOS) velocity and line core intensity maps and were located in a segment of the sunspot that showed a regular penumbra in the photosphere. The chromospheric LOS velocity abruptly decreases from 3 to 15 km/s to zero at the inner footpoints of the fibrils that are located from the mid penumbra to about 1.4 spot radii. The spectra often show multiple components, i.e., one at the rest wavelength and one with a strong red shift, which indicates spatially or vertically unresolved structures. The line-core intensity always peaks slightly closer to the umbra than the LOS velocity. An inversion of the spectra with the CAlcium Inversion using a Spectral ARchive (CAISAR) code provided us with temperature stratifications that allowed us to trace individual fibrils through the atmosphere and to determine the angle of the flows relative to the surface without any additional assumptions on the flow topology such as radial symmetry. We find that the fibrils are not horizontal near the downflow points, but make an angle of 30 to 60 degrees to the local vertical. The temperature is enhanced by 200K at log(tau) ~ -2 and up to 2000K at log(tau) ~ -6 over that of the quiet Sun, whereas there is no signature in the low photosphere. Our results are consistent with a critical, i.e., sonic, or super-sonic siphon flow along super-penumbral flux tubes in which accelerating plasma abruptly attains sub-critical velocity through a standing shock in or near the penumbra as predicted by Montesinos & Thomas (1993).

Original Article:

Disentangling flows in the solar transition region

P. Zacharias, V. H. Hansteen, J. Leenaarts, M. Carlsson, B. V. Gudiksen

The measured average velocities in solar and stellar spectral lines formed at transition region temperatures have been difficult to interpret. However, realistic three-dimensional radiation magnetohydrodynamics (3D rMHD) models of the solar atmosphere are able to reproduce the observed dominant line shifts and may thus hold the key to resolve these issues. Our new 3D rMHD simulations aim to shed light on how mass flows between the chromosphere and corona and on how the coronal mass is maintained. Passive tracer particles, so-called corks, allow the tracking of parcels of plasma over time and thus the study of changes in plasma temperature and velocity not only locally, but also in a co-moving frame. By following the trajectories of the corks, we can investigate mass and energy flows and understand the composition of the observed velocities. Our findings show that most of the transition region mass is cooling. The preponderance of transition region redshifts in the model can be explained by the higher percentage of downflowing mass in the lower and middle transition region. The average upflows in the upper transition region can be explained by a combination of both stronger upflows than downflows and a higher percentage of upflowing mass. The most common combination at lower and middle transition region temperatures are corks that are cooling and traveling downward. For these corks, a strong correlation between the pressure gradient along the magnetic field line and the velocity along the magnetic field line has been observed, indicating a formation mechanism that is related to downward propagating pressure disturbances. Corks at upper transition region temperatures are subject to a rather slow and highly variable but continuous heating process.

Original Article: