Coronal hard X-ray sources revisited

Brian R. Dennis, Miguel A. Duval-Poo, Michele Piana, Andrew R. Inglis, A. Gordon Emslie, Jingnan Guo, Yan Xu

This paper reports on the re-analysis of solar flares in which the hard X-rays (HXRs) come predominantly from the corona rather than from the more usual chromospheric footpoints. All of the 26 previously analyzed event time intervals, over 13 flares, are re-examined for consistency with a flare model in which electrons are accelerated near the top of a magnetic loop that has a sufficiently high density to stop most of the electrons by Coulomb collisions before they can reach the footpoints. Of particular importance in the previous analysis was the finding that the length of the coronal HXR source increased with energy in the 20 – 30 keV range. However, after allowing for the possibility that footpoint emission at the higher energies affects the inferred length of the coronal HXR source, and using analysis techniques that suppress the possible influence of such footpoint emission, we conclude that there is no longer evidence that the length of the HXR coronal sources increase with increasing energy. In fact, for the 6 flares and 12 time intervals that satisfied our selection criteria, the loop lengths decreased on average by 1.0 +/- 0.2 arcsec between 20 and 30 keV, with a standard deviation of 3.5 arcsec. We find strong evidence that the peak of the coronal HXR source increases in altitude with increasing energy. For the thermal component of the emission, this is consistent with the standard CHSKP flare model in which magnetic reconnection in a coronal current sheet results in new hot loops being formed at progressively higher altitudes. The explanation for the nonthermal emission is not so clear.

Original Article: http://arxiv.org/abs/1809.04631

The coronal volume of energetic particles in solar flares as revealed by microwave imaging

Gregory D. Fleishman, Maria A. Loukitcheva, Varvara Yu. Kopnina, Gelu M. Nita, Dale E. Gary

The spectrum of gyrosynchrotron emission from solar flares generally peaks in the microwave range. Its optically-thin, high-frequency component, above the spectral peak, is often used for diagnostics of the nonthermal electrons and the magnetic field in the radio source. Under favorable conditions, its low-frequency counterpart brings additional, complementary information about these parameters as well as thermal plasma diagnostics, either through gyrosynchrotron self-absorption, free-free absorption by the thermal plasma, or the suppression of emission through the so-called Razin effect. However, their effects on the low-frequency spectrum are often masked by spatial nonuniformity. To disentangle the various contributions to low-frequency gyrosynchrotron emission, a combination of spectral and imaging data is needed. To this end, we have investigated Owens Valley Solar Array (OVSA) multi-frequency images for 26 solar bursts observed jointly with Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI) during the first half of 2002. For each, we examined dynamic spectra, time- and frequency-synthesis maps, RHESSI images with overlaid OVSA contours, and a few representative single-frequency snapshot OVSA images. We focus on the frequency dependence of microwave source sizes derived from the OVSA images and their effect on the low-frequency microwave spectral slope. We succeed in categorizing 18 analyzed events into several groups. Four events demonstrate clear evidence of being dominated by gyrosynchrotron self-absorption, with an inferred brightness temperature of $\geq10^8$~K. The low-frequency spectra in the remaining events are affected to varying degree by Razin suppression. We find that many radio sources are rather large at low frequencies, which can have important implications for solar energetic particle production and escape.

Original Article: http://arxiv.org/abs/1809.04753

Evolution of the solar Ly-$\alpha$ line profile during the solar cycle. II. How accurate is the present radiation pressure paradigm for interstellar neutral H in the heliosphere?

Izabela Kowalska-Leszczynska, Maciej Bzowski, Justyna M. Sokół, Marzena A. Kubiak

Following the derivation of a more accurate model of the evolution of the solar Lyman-$\alpha$ line with the changing solar activity by Kowalska-leszczynska et al. 2018 (IKL18) than the formerly used model by Tarnopolski et al. 2009 (ST09), we investigate potential consequences that adoption of the resulting refined model of radiation pressure has for the model distribution of interstellar neutral (ISN) H in the inner heliosphere and on the interpretation of selected observations. We simulated the ISN H densities using the two alternative radiation pressure models and identical models of all other factors affecting the ISN H distribution. We found that during most of the solar cycle, the IKL18 model predicts larger densities of ISN H and PUIs than ST09 in the inner heliosphere, especially in the downwind hemisphere. However, the density of ISN H at the termination shock estimated by Bzowski et al. 2008 obtained using ST09 does not need revision, and the detection of ISN D by IBEX is supported. However, we point out the existence of a considerable absorption of a portion of the solar Lyman-$\alpha$ spectral flux inside the heliosphere. Therefore, the model of radiation pressure for ISN H is still likely needs revision, and hence the available models of ISN H are not self-consistent.

Original Article: http://arxiv.org/abs/1809.04929

Casting the Coronal Magnetic Field Reconstruction Tools in 3D Using MHD Bifrost Model

Gregory D. Fleishman, Sergey Anfinogentov, Maria Loukitcheva, Ivan Mysh’yakov, Alexey Stupishin

Quantifying coronal magnetic field remains a central problem in solar physics. Nowadays the coronal magnetic field is often modelled using nonlinear force-free field (NLFFF) reconstructions, whose accuracy has not yet been comprehensively assessed. Here we perform a detailed casting of the NLFFF reconstruction tools, such as pi-disambiguation, photospheric field preprocessing, and volume reconstruction methods using a 3D snapshot of the publicly available full-fledged radiative MHD model. Specifically, from the MHD model we know the magnetic field vector in the entire 3D domain, which enables us to perform "voxel-by-voxel" comparison of the restored and the true magnetic field in the 3D model volume. Our tests show that the available pi-disambiguation methods often fail at the quiet sun areas dominated by small-scale magnetic elements, while they work well at the AR photosphere and (even better) chromosphere. The preprocessing of the photospheric magnetic field, although does produce a more force-free boundary condition, also results in some effective `elevation’ of the magnetic field components. This `elevation’ height is different for the longitudinal and transverse components, which results in a systematic error in absolute heights in the reconstructed magnetic data cube. The extrapolations performed starting from actual AR photospheric magnetogram are free from this systematic error, while have other metrics comparable with those for extrapolations from the preprocessed magnetograms. This finding favors the use of extrapolations from the original photospheric magnetogram without preprocessing. Our tests further suggest that extrapolations from a force-free chromospheric boundary produce measurably better results, than those from the photospheric boundary.

Original Article: http://arxiv.org/abs/1703.06360