Statistics of coronal dimmings associated with coronal mass ejections. II. Relationship between coronal dimmings and their associated CMEs

Karin Dissauer, Astrid M. Veronig, Manuela Temmer, Tatiana Podladchikova

We present a statistical study of 62 coronal dimming events associated with Earth-directed CMEs during the quasi-quadrature period of STEREO and SDO. This unique setting allows us to study both phenomena in great detail and compare characteristic quantities statistically. Coronal dimmings are observed on-disk by SDO/AIA and HMI, while the CME kinematics during the impulsive acceleration phase is studied close to the limb with STEREO/EUVI and COR, minimizing projection effects. The dimming area, its total unsigned magnetic flux and its total brightness, reflecting properties of the total dimming region at its final extent, show the highest correlations with the CME mass ($c\sim0.6-0.7$). Their corresponding time derivatives, describing the dynamics of the dimming evolution, show the strongest correlations with the CME peak velocity ($c\sim 0.6$). The highest correlation of $c=0.68\pm0.08$ is found with the mean intensity of dimmings, indicating that the lower the CME starts in the corona, the faster it propagates. No significant correlation between dimming parameters and the CME acceleration was found. However, for events where high-cadence STEREO observations were available, the mean unsigned magnetic field density in the dimming regions tends to be positively correlated with the CME peak acceleration ($c=0.42\pm0.20$). This suggests that stronger magnetic fields result in higher Lorentz forces providing stronger driving force for the CME acceleration. Specific coronal dimming parameters correlate with both, CME and flare quantities providing further evidence for the flare-CME feedback relationship. For events in which the CME occurs together with a flare, coronal dimmings statistically reflect the properties of both phenomena.

Original Article: http://arxiv.org/abs/1810.01589

Modeling Inner Boundary Values at 18 Solar Radii During Solar Quiet time for Global Three-dimensional Time-Dependent Magnetohydrodynamic Numerical Simulation

Chin-Chun Wu, Kan Liou, Simon Plunkett, Dennis Socker, Y.M. Wang, Brian Wood, S. T. Wu, Murray Dryer, Christopher Kung

The solar wind speed plays a key role in the transport of CME out of the Sun and ultimately determines the arrival time of CME-driven shocks in the heliosphere. Here, we develop an empirical model of the solar wind parameters at the inner boundary (18 solar radii, Rs) used in our global, 3D MHD model (G3DMHD) or other equivalent ones. The model takes solar magnetic field maps at 2.5 Rs (which is based on the Potential Field Source Surface, PFSS model) and interpolates the solar wind plasma and field out to 18 Rs using the algorithm of Wang and Sheeley [1990a]. A formula V_{18Rs} = V1 + V2 fs^{\alpha} is used to calculate the solar wind speed at 18 Rs, where V1 is in a range of 150-350 km/s, V2 is in the range of 250-500 km/s, and fs is an expansion factor, which was derived from the Wang and Sheeley (WS) algorithm at 2.5 Rs. To estimate the solar wind density and temperature at 18 Rs, we assume an incompressible solar wind and a constant total pressure. The three free parameters are obtained by adjusting simulation results to match in-situ observations (Wind) for more than 54 combination of V1, V2 and {\alpha} during a quiet solar wind interval, CR2082. We found V18Rs = (150 +/- 50) + (500 +/- 100) fs^-0.4 km/s performs reasonably well in predicting solar wind parameters at 1 AU not just for CR 2082 but other quiet solar period. Comparing results from the present study with those from WSA [Arge et al. 2000; 2004] we conclude that i) Results of using V_{18Rs} with the full rotation data (FR) as input to drive G3DMHD model is better than the results of WSA using FR, or daily updated. ii) When using a modified daily updated 4-day-advanced solar wind speed predictions WSA performs slightly better than our G3DMHD. iii) When using V_{18Rs} as input, G3DMHD model performs much better than the WSA formula. We argue the necessity of the extra angular width ({\theta}b) parameter used in WSA.

Original Article: http://arxiv.org/abs/1810.01755

Damping of slow surface sausage modes in photospheric waveguides

Shao-Xia Chen, Bo Li, Mijie Shi, Hui Yu

There has been considerable interest in sausage modes in photospheric waveguides like pores and sunspots, and slow surface sausage modes (SSSMs) have been suggested to damp ufficiently rapidly to account for chromospheric heating. Working in the framework of linear resistive magnetohydrodynamics, we examine how efficient electric resistivity and resonant absorption in the cusp continuum can be for damping SSSMs in a photospheric waveguide with equilibrium parameters compatible with recent measurements of a photospheric pore. For SSSMs with the measured wavelength, we find that the damping rate due to the cusp resonance is substantially less strong than theoretically expected with the thin-boundary approximation. The damping-time-to-period ratio ($\tau/P$) we derive for standing modes, equivalent to the damping-length-to-wavelength ratio for propagating modes given the extremely weak dispersion, can reach only $\sim 180$. However, the accepted values for electric resistivity ($\eta$) correspond to a regime where both the cusp resonance and resistivity play a role. The values for $\tau/P$ attained at the largest allowed $\eta$ may reach $\sim 30$. We conclude that electric resistivity can be considerably more efficient than the cusp resonance for damping SSSMs in the pore in question, and it needs to be incorporated into future studies on the damping of SSSMs in photospheric waveguides in general.

Original Article: http://arxiv.org/abs/1810.02051

The Association of Filaments, Polarity Inversion Lines, and Coronal Hole Properties with the Sunspot Cycle: An Analysis of the McIntosh Database

Rakesh Mazumder, Prantika Bhowmik, Dibyendu Nandy

Filaments and coronal holes, two principal features observed in the solar corona are sources of space weather variations. Filament formation is closely associated with polarity inversion lines (PIL) on the solar photosphere which separate positive and negative polarities of the surface magnetic field. The origin of coronal holes is governed by large-scale unipolar magnetic patches on the photosphere from where open magnetic field lines extend to the heliosphere. We study properties of filaments, PILs and coronal holes in solar cycles 20, 21, 22 and 23 utilizing the McIntosh archive. We detect a prominent cyclic behavior of filament length, PIL length, and coronal hole area with significant correspondence with the solar magnetic cycle. The spatio-temporal evolution of the geometric centers of filaments shows a butterfly-like structure and distinguishable pole-ward migration of long filaments during cycle maxima. We identify this rush to the poles of filaments to be co-temporal with the initiation of polar field reversal as gleaned from Mount Wilson and Wilcox Solar Observatory polar field observations and quantitatively establish their temporal correspondence. We analyze the filament tilt angle distribution to constrain their possible origins. Majority of the filaments exhibit negative and positive tilt angles in the northern and the southern hemispheres, respectively — strongly suggesting that their formation is governed by the overall large-scale magnetic field distribution on the solar photosphere and not by the small-scale intra-active region magnetic field configurations. We also investigate the hemispheric asymmetry in filaments, PILs, and coronal holes. We find that the hemispheric asymmetry in filaments and PILs are positively correlated — whereas coronal hole asymmetry is uncorrelated — with sunspot area asymmetry.

Original Article: http://arxiv.org/abs/1810.02133

Solar neutrino flare, megaton neutrino detectors and human space journey

Danile Fargion, Pietro Oliva, Silvia Pietroni, Fabio La Monaca, Paolo Paggi, Emanuele Habib, Maxim Khlopov

The largest solar flare have been recorded in gamma flash and hard spectra up to tens GeV energy. The present building and upgrade of Hyper- Kamiokande (HK) in Japan and Korea, (as well as Deep Core, PINGU) Megatons neutrino detectors do offer a novel way to detectable trace of solar flares: their sudden anti-neutrino (or neutrino) imprint made by proton scattering and pion decays via Delta resonance production on solar corona foot-point. These signals might be observable at largest flare by HK via soft spectra up to tens-hundred MeV energy and by IceCube-PINGU at higher, GeVs energies. We show the expected rate of signals for the most powerful solar flare occurred in recent decades extrapolated for future Megaton detectors. The neutrino solar flare detection with its prompt alarm system may alert astronauts on space journey allowing them to hide themselves into inner rocket container surrounded by fuel or water supply. These container walls are able to defend astronauts from the main lethal (the dominant soft component) radiation wind due to such largest solar flares.

Original Article: http://arxiv.org/abs/1809.02004

High-Density Off-Limb Flare Loops Observed by SDO

S. Jejčič, L. Kleint, P. Heinzel

The density distribution of flare loops and the mechanisms of their emission in the continuum are still open questions. On September 10, 2017 a prominent loop system appeared during the gradual phase of an X8.2 flare (SOL2017-09-10), visible in all passbands of SDO/AIA and in the white-light continuum of SDO/HMI. We investigate its electron density by taking into account all radiation processes in the flare loops, i.e. the Thomson continuum, hydrogen Paschen and Brackett recombination continua, as well as free-free continuum emission. We derive a quadratic function of the electron density for a given temperature and effective loop thickness. By absolutely calibrating SDO/HMI intensities, we convert the measured intensities into electron density at each pixel in the loops. For a grid of plausible temperatures between cool (6000 K) and hot (10^6 K) structures, the electron density is computed for representative effective thicknesses between 200 and 20 000 km. We obtain a relatively high maximum electron density, about 10^13 cm^-3. At such high electron densities, the Thomson continuum is negligible and therefore one would not expect a significant polarization degree in dense loops. We conclude that the Paschen and Brackett recombination continua are dominant in cool flare loops, while the free-free continuum emission is dominant for warmer and hot loops.

Original Article: http://arxiv.org/abs/1810.02431

On Kelvin-Helmholtz and parametric instabilities driven by coronal waves

Andrew Hillier, Adrian Barker, Iñigo Arregui, Henrik Latter

The Kelvin-Helmholtz instability has been proposed as a mechanism to extract energy from magnetohydrodynamic (MHD) kink waves in flux tubes, and to drive dissipation of this wave energy through turbulence. It is therefore a potentially important process in heating the solar corona. However, it is unclear how the instability is influenced by the oscillatory shear flow associated with an MHD wave. We investigate the linear stability of a discontinuous oscillatory shear flow in the presence of a horizontal magnetic field within a Cartesian framework that captures the essential features of MHD oscillations in flux tubes. We derive a Mathieu equation for the Lagrangian displacement of the interface and analyse its properties, identifying two different instabilities: a Kelvin-Helmholtz instability and a parametric instability involving resonance between the oscillatory shear flow and two surface Alfv\'{e}n waves. The latter occurs when the system is Kelvin-Helmholtz stable, thus favouring modes that vary along the flux tube, and as a consequence provides an important and additional mechanism to extract energy. When applied to flows with the characteristic properties of kink waves in the solar corona, both instabilities can grow, with the parametric instability capable of generating smaller scale disturbances along the magnetic field than possible via the Kelvin-Helmholtz instability. The characteristic time-scale for these instabilities is $\sim 100$ s, for wavelengths of $200$ km. The parametric instability is more likely to occur for smaller density contrasts and larger velocity shears, making its development more likely on coronal loops than on prominence threads.

Original Article: http://arxiv.org/abs/1810.02773