Solar neutrino flare, megaton neutrino detectors and human space journey

Danile Fargion, Pietro Oliva, Silvia Pietroni, Fabio La Monaca, Paolo Paggi, Emanuele Habib, Maxim Khlopov

The largest solar flare have been recorded in gamma flash and hard spectra up to tens GeV energy. The present building and upgrade of Hyper- Kamiokande (HK) in Japan and Korea, (as well as Deep Core, PINGU) Megatons neutrino detectors do offer a novel way to detectable trace of solar flares: their sudden anti-neutrino (or neutrino) imprint made by proton scattering and pion decays via Delta resonance production on solar corona foot-point. These signals might be observable at largest flare by HK via soft spectra up to tens-hundred MeV energy and by IceCube-PINGU at higher, GeVs energies. We show the expected rate of signals for the most powerful solar flare occurred in recent decades extrapolated for future Megaton detectors. The neutrino solar flare detection with its prompt alarm system may alert astronauts on space journey allowing them to hide themselves into inner rocket container surrounded by fuel or water supply. These container walls are able to defend astronauts from the main lethal (the dominant soft component) radiation wind due to such largest solar flares.

Original Article:

High-Density Off-Limb Flare Loops Observed by SDO

S. Jejčič, L. Kleint, P. Heinzel

The density distribution of flare loops and the mechanisms of their emission in the continuum are still open questions. On September 10, 2017 a prominent loop system appeared during the gradual phase of an X8.2 flare (SOL2017-09-10), visible in all passbands of SDO/AIA and in the white-light continuum of SDO/HMI. We investigate its electron density by taking into account all radiation processes in the flare loops, i.e. the Thomson continuum, hydrogen Paschen and Brackett recombination continua, as well as free-free continuum emission. We derive a quadratic function of the electron density for a given temperature and effective loop thickness. By absolutely calibrating SDO/HMI intensities, we convert the measured intensities into electron density at each pixel in the loops. For a grid of plausible temperatures between cool (6000 K) and hot (10^6 K) structures, the electron density is computed for representative effective thicknesses between 200 and 20 000 km. We obtain a relatively high maximum electron density, about 10^13 cm^-3. At such high electron densities, the Thomson continuum is negligible and therefore one would not expect a significant polarization degree in dense loops. We conclude that the Paschen and Brackett recombination continua are dominant in cool flare loops, while the free-free continuum emission is dominant for warmer and hot loops.

Original Article:

On Kelvin-Helmholtz and parametric instabilities driven by coronal waves

Andrew Hillier, Adrian Barker, Iñigo Arregui, Henrik Latter

The Kelvin-Helmholtz instability has been proposed as a mechanism to extract energy from magnetohydrodynamic (MHD) kink waves in flux tubes, and to drive dissipation of this wave energy through turbulence. It is therefore a potentially important process in heating the solar corona. However, it is unclear how the instability is influenced by the oscillatory shear flow associated with an MHD wave. We investigate the linear stability of a discontinuous oscillatory shear flow in the presence of a horizontal magnetic field within a Cartesian framework that captures the essential features of MHD oscillations in flux tubes. We derive a Mathieu equation for the Lagrangian displacement of the interface and analyse its properties, identifying two different instabilities: a Kelvin-Helmholtz instability and a parametric instability involving resonance between the oscillatory shear flow and two surface Alfv\'{e}n waves. The latter occurs when the system is Kelvin-Helmholtz stable, thus favouring modes that vary along the flux tube, and as a consequence provides an important and additional mechanism to extract energy. When applied to flows with the characteristic properties of kink waves in the solar corona, both instabilities can grow, with the parametric instability capable of generating smaller scale disturbances along the magnetic field than possible via the Kelvin-Helmholtz instability. The characteristic time-scale for these instabilities is $\sim 100$ s, for wavelengths of $200$ km. The parametric instability is more likely to occur for smaller density contrasts and larger velocity shears, making its development more likely on coronal loops than on prominence threads.

Original Article:

Hemispheric Preference and Cyclic Variation of Solar Filament Chirality from 2000 to 2016

Soumitra Hazra, Sushant S. Mahajan, William Keith Douglas Jr., Petrus C. H. Martens

It is well known that solar filaments are features in the solar atmosphere which show a hemispheric preference in their chirality. The hemispheric preference is such that the dextral chirality dominates in the northern hemisphere while the sinistral chirality dominates in the southern. Determining the strength and cyclic variation of the degree of this hemispheric preference, however, is challenging and tedious and thus needs to be automated. In this paper, we follow Dr. Pietro Bernasconi’s algorithm (Bernasconi et al. 2005) to detect filament chirality with two parallel channels of application. The algorithm is applied to H-alpha images by "Advanced Automated Filament Detection and Characterization Code" (AAFDCC) (Bernasconi et al. 2005) or the algorithm is explained to a human and the human determines the chirality of the solar filament. We have conducted this exercise on data during the month of August from years 2000 to 2016 and we found that 83 % of our visually determined filaments follow the hemispheric chirality preference, while 58 % of automatically determined filaments follow it. Our visually compiled results have over 90 % agreement with those of Pevtsov et al. (2003), yet the visually determined chiralities of filaments disagree with automated determinations significantly. We find that the hemispheric preference remained the same between solar cycles 23 and 24 but the preference is very difficult to determine during the solar minimum of 2008-2010 primarily due to the absence of filaments.

Original Article:

Study of the polarization produced by the Zeeman effect in the solar Mg I b lines

C. Quintero Noda, H. Uitenbroek, M. Carlsson, D. Orozco Suárez, Y. Katsukawa, T. Shimizu, B. Ruiz Cobo, M. Kubo, T. Oba, Y. Kawabata, T. Hasegawa, K. Ichimoto, T. Anan, Y. Suematsu

The next generation of solar observatories aim to understand the magnetism of the solar chromosphere. Therefore, it is crucial to understand the polarimetric signatures of chromospheric spectral lines. For this purpose, we here examine the suitability of the three Fraunhofer Mg I b1, b2, and b4 lines at 5183.6, 5172.7, and 5167.3 A, respectively. We start by describing a simplified atomic model of only 6 levels and 3 line transitions for computing the atomic populations of the 3p-4s (multiplet number 2) levels involved in the Mg I b line transitions assuming non-local thermodynamic conditions and considering only the Zeeman effect using the field-free approximation. We test this simplified atom against more complex ones finding that, although there are differences in the computed profiles, they are small compared with the advantages provided by the simple atom in terms of speed and robustness. After comparing the three Mg I lines, we conclude that the most capable one is the b2 line as b1 forms at similar heights and always show weaker polarization signals while b4 is severely blended with photospheric lines. We also compare Mg I b2 with the K I D1 and Ca II 8542 A lines finding that the former is sensitive to the atmospheric parameters at heights that are in between those covered by the latter two lines. This makes Mg I b2 an excellent candidate for future multi-line observations that aim to seamlessly infer the thermal and magnetic properties of different features in the lower solar atmosphere.

Original Article:

Can high-mode magnetohydrodynamic waves propagating in a rotating microspicule become unstable against Kelvin–Helmholtz instability?

I. Zhelyazkov, R. Chandra

We investigate the conditions under which high-mode magnetohydrodynamic (MHD) waves propagating in a rotating solar microspicule become unstable against the Kelvin–Helmholtz instability (KHI). We model the microspicule as a weakly twisted cylindrical magnetic flux tube moving along and rotating around its axis. We use the dispersion relation of MHD modes obtained from the linearized MHD equations of incompressible plasma for the jet and cool (zero beta) plasma for its environment by assuming real wave numbers and complex angular wave frequencies/complex wave phase velocities. The dispersion equation is solved numerically at appropriate input parameters to find out an instability region/window that accommodates suitable unstable wavelengths of the order of microspicule’s width. It is established that a $m = 39$ MHD mode propagating in a microspicule with width of $6$~Mm, axial velocity of $75$~km\,s$^{-1}$ and rotating one of $40$~km\,s$^{-1}$ can become unstable against KHI with instability growth times of $3.4$ and $0.73$~min at $3$ and $5$~Mm unstable wavelengths, respectively. These growth times are much shorter than the macrospicule lifetime of around $15$~min. An increase/decease in the width of the jet would change the KHI growth times remaining more or less of the same order when are evaluated at wavelengths equal to the width/radius of the macrospicule. It is worth noticing that the excited MHD modes are supper-Alfv\’enic waves.

Original Article:

Automated detection of small-scale magnetic flux ropes in the solar wind: First results from the Wind spacecraft measurements

Qiang Hu, Jinlei Zheng, Yu Chen, Jakobus le Roux, Lulu Zhao

We have developed a new automated small-scale magnetic flux rope (SSMFR) detection algorithm based on the Grad-Shafranov (GS) reconstruction technique. We have applied this detection algorithm to the Wind spacecraft in-situ measurements during 1996 – 2016, covering two solar cycles, and successfully detected a total number of 74,241 small-scale magnetic flux rope events with duration from 9 to 361 minutes. This large number of small-scale magnetic flux ropes has not been discovered by any other previous studies through this unique approach. We perform statistical analysis of the small-scale magnetic flux rope events based on our newly developed database, and summarize the main findings as follows. (1) The occurrence of small-scale flux ropes has strong solar cycle dependency with a rate of a few hundreds per month on average. (2) The small-scale magnetic flux ropes in the ecliptic plane tend to align along the Parker spiral. (3) In low speed ($<$ 400 km/s) solar wind, the flux ropes tend to have lower proton temperature and higher proton number density, while in high speed ($\ge$ 400 km/s) solar wind, they tend to have higher proton temperature and lower proton number density. (4) Both the duration and scale size distributions of the small-scale magnetic flux ropes obey a power law. (5) The waiting time distribution of small-scale magnetic flux ropes can be fitted by an exponential function (for shorter waiting times) and a power law function (for longer waiting times). (6) The wall-to-wall time distribution obeys double power laws with the break point at 60 minutes (corresponding to the correlation length). (7) The small-scale magnetic flux ropes tend to accumulate near the heliospheric current sheet (HCS). The entire database is available at \url{this http URL} and in machine readable format in this article.

Original Article: